Troubleshooting - Philips 150P4CG Service Manual

http://www.jdwxzlw.com/?fromuser=华盛维修

TROUBLESHOOTING

This page presents problems that can be corrected by the user. If the
problem still exists after these possible solutions, a further action has
to be take by authorized technicians.
No Picture
Make sure the Power cable is plugged to the
(Power LED not lit)
wall and back of the monitor.
Make sure the DC power cord has been
attached to the DC jack.
First, power button in front of the monitor
should be in the OFF position, then press it to
ON position again.
No Picture Make sure the computer is turned on.
(Power LED is Make sure the signal cable is properly
Amber or Green in connected to your computer.
color) Check to see if the monitor cable has bent pins.
The Energy Saving Feature may be activated.
Screen says Make sure the monitor cable is properly
connected to your computer.
Check to see if the monitor cable has bent pins.
Make sure the computer is turned on.
The Auto Function is designed for
AUTO button not
use on standard Macintosh or
working
IBM-compatible PC running Microsoft Windows.
properly
It may not work properly if using
non-standard PCs or video card.
Push the AUTO button.
Display position
Adjust the image position using the Horizontal
is incorrect
Position & / or Vertical Position in the Second
Window.
Check that the signal cable is properly
Image vibrates
connected to the graphics board or PC.
on the screen
Push the AUTO button.
Vertical flicker
Eliminate the vertical bars using the Clock
appears
Adjustment in the FIRST Window.
家电维修资料网，免费下载各种维修资料
Trouble Shooting
Horizontal flicker
appears
The screen is too
bright or too dark
An after-image
appears
An after-image
remains after the
power has been
turned off
Green, red,
blue, dark and
white dots
remain on the
screen
150P4 LCD
Go to cover page
Push the Auto button.
Eliminate the horizontal bars using the Phase
Adjustment in the First Window.
Adjust the contrast and brightness using the
First Window.
(The backlight of the LCD monitor has a fixed
life span. When the screen becomes dark or
begins to flicker,please contact your dealer.)
If an image remains in the screen for an
extended period of time,it may be imprinted in
the screen and leave an after-image. This
usually disappears after a few hours.
This is characteristic of liquid crystal and is
not caused by a malfunction or deterioration
of the liquid crystal. The after-image will
disappear after a set amount of time.
The remaining dots are normal
charactericstic of the liquid crystal used in
today's technology.
11