Technical Data & Power Management; Technical Specifications - Philips 150P4CG Service Manual

http://www.jdwxzlw.com/?fromuser=华盛维修

Technical Specifications

LCD Panel
Type
Screen size
Pixel pitch
LCD Panel type
Effective viewing area
Display Colors
SCANNING
Horizontal scan range
Vertical scan range
Video
Video dot rate
input impedance
-Video
-Sync
Input signal levels
Sync input signals
Sync polarities
Input Frequency
Video interface
Resolution and Preset Modes
Maximum
Recommended
Optical Characteristics
Contrast ratio
Brightness
Peak contrast angle
White chromacity
Viewing angle (CR>5)
Response time
Physical Characteristics
Dimensions(WXHXD)
Weight (monitor only)
Tilt Forward / Backward
AC input voltage / frequency
Power consumption
Temperature ( Operating)
Relative Humidity
Pin Assignment
DVI-D connector
(Digital Visual Interface - Digital)
16
17
家电维修资料网，免费下载各种维修资料
Technical Data
: TFT LCD
: 15" Visual
: 0.297 x 0.297 mm(15.0")
: 1024x 768 pixels
R.G.B. Vertical stripe
Anti0glare polarizer, hard coated
: 304.1 X 228.1 mm(15.0")
: 16.7M colors
: 30 kHz to 61 kHz (automatic)
: 56 Hz to 76 Hz (automatic)
: 80MHz
: 75 ohms
: 2 KOhm
: 700m Vpp
: Separate sync
composite sync
Sync on Green
: Positive and negative
: XGA Hsync
48-61 KHz,Vsync 60-76Hz(N.I.)
SVGA Hsync
35-50 KHz,Vsync 56-75Hz(N.I.)
VGA Hsync
31-38 KHz,Vsync 60-76Hz(N.I.)
: Dual input:Both Analog(D-Sub) and
DVI-D (Digital only) are available.
It can be switched via OSD selection
: 1024 x 768 at 75Hz
: 1024 x 768 at 60Hz
: 400(typ.)
2
: 250 cd/m (typ.)
: 6 o clock ,
: x:0.283 y:0.297 (at 9300 k) o
x:0.313 y:0.329 (at 6500 k) o
x:0.313 y:0.329 (at sRGB)
o
: Upper>=50 (typ.)Lower>=60 (type) °
Left and Right >=75 (typ.) °
: <=25ms(typ.)
:343x297x218mm(incl.pedestal)
: 3.6 kg
o o
: -5 / 25
: 100 to 240 VAC / 50 or 60 Hz
: 20 W (typ.)
: 5 C to 40 C ° °
: 20% to 80%
Pin Assignment
The digital only connector contains 24 signal contacts organized in three rows of eight
contacts. Signal pin assignments are listed in the Table:
Pin Signal Pin Signal
No. Assignment No. Assignment
T.M.D. S. T.M.D.S.
1 9
Data2 - Data1 -
T.M.D.S. T.M.D.S.
2 10
Data2+ Data1+
T.M.D.S. T.M.D.S.
3 11
Data2/4 Shield Data1/3 Shield
4 No connect 12 No connect
5 No conn ect 13 No connect
6 DDC Clock 14 +5V Power
Ground (for
7 DDC Data 15
+5V)
Hot Plug
8 No connect 16
Detect
2. The 15-pin D-sub connector (male) of the signal cable
Pin
Assignment
No.
1 Red video input
2 Green video input
3 Blue video input
Identical output -
4
connected to pin 10
5 Cable detect
6 Red video ground
7 Green video ground
8 Blue video ground
150P4 LCD 3
Go to cover page
Pin Signal
No. Assignment
T.M.D.S.
17
Data0 -
T.M.D.S.
18
Data0+
T.M.D.S.
19
Data0/5 Shield
20 No connect
21 No connect
T.M.D.S. Clock
22
Shield
T.M.D.S.
23
Clock+
T.M.D.S.
24
Clock -
Pin
Assignment
No.
9 DDC+5V
10 Logic ground
Identical output -
11
connected to pin 10
Serial data line
12
(SDA)
13 H. Sync / H+V
14 V. Sync
15 Data clock line (SCL)