Selecting Input Source; Channel Recall; Channel Selection - Sanyo LCD-19K40 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Select mode "TV", "AV1-S", "AV2", "HDMI" or "PC" by pressing INPUT button on Remote Control or on

Side Controls, you can also press POINT ▲▼ buttons to select different mode. To enter the selected mode,

press ENTER button or POINT ◄► buttons.

INPUT

1. TV

2. AV1-S

3. AV2

4. HDMI

5. PC

: SELECT

: EXIT

1~5

BACK

Note:

● User can directly displayed selected input source by

pressing NUMERIC buttons (1-5) on Remote Control.

Press CHANNEL RECALL button to switch between

the previous channel and the current channel.

For example, now you are watching channel "4", but

you watched channel "2" previously. If you press

CHANNEL RECALL button, channel "2" will appear

immediately.

There are 256 channels can be selected on the LCD TV.

For direct access to programmes using the (0-9) numeric buttons.

1) For selection of channel position 0 - 9. Example: For

channel position 8, press "8" button.

2) For selection of channel position 10 - 99. Example:

For channel position 25, press the DIGIT button to

display "- -", then press "2" and "5" buttons.

3) For selection of channel position 100 - 199. Example:

For channel position 125, press the DIGIT button

twice to display "1 - -", then press "2" and "5" buttons.

4) For selection of channel position 200 - 255.

Example: For channel position 225, press the DIGIT

button three times to display "2 - -", then press "2"

and "5" buttons.

Press CHANNEL UP/DOWN (▲▼) buttons on Side Control or on Remote Control to select programs.

● Press CHANNEL UP (▲) button to select next channel.

● Press CHANNEL DOWN (▼) button to select previous channel.

Note:

CHANNEL RECALL and CHANNEL SELECTION function only use in TV mode.