Miele PT 7135 C Vario Operating And Installation Instructions page 24

Short instructions
D Start the programme
The Start button will flash as soon as a
programme can be started.
^ Press the Start button.
The Start button will now light up.
– Prog. running will appear in the
display, followed by Drying and the
programme duration.
– With sensor drying programmes, e.g.
Machine iron ... Hand iron etc., the
drying level reached will be shown in
the display later on.
Once drying is in progress, you can
press one of the short cut buttons:
– Button E Timer to call up the
estimated end time of the
programme and the current time of
day.
– Button F Save to save the current
programme as a favourite.
– Button G Cancel to cancel the
current programme.
This only applies to machines with a
payment system, if a programme can
be cancelled without the loss of
credit.
See section "Changing the programme
sequence" for further information about
the following:
– Payment system
– Changing a programme once it has
started
– Cancelling the current programme
– Adding or removing laundry after a
programme has started
24
– Interruption to the power supply
– Time remaining
Programme duration/Estimated time
remaining
When a programme is selected, the
estimated duration will appear in the
display. Please be aware that it is only
an estimate!
The following factors all affect the
estimated time remaining: residual
moisture content after spinning; type of
fabric; size of load; room temperature;
fluctuations in power supply.
The electronics assess conditions in the
dryer and adjust the estimated time
remaining for a more accurate reading.
Because of this, the time displayed can
alter during the course of a programme.
Before the end of a programme
In many programmes the heating
phase is followed by the cooling down
phase: Cooling down will appear in the
display. The programme is not finished
until the cooling down phase has been
completed.
Do not switch the tumble dryer off
before the end of the drying
programme.