Surfaces In The Cooking Compartment - Bosch CMG636B.1 Instruction Manual

Cleaning agent
en
Door panels Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
Do not use a glass scraper or a stainless steel
scouring pad.
Door handle Hot soapy water:
Clean with a dish cloth and then dry with a soft
cloth.
If descaler comes into contact with the door han-
dle, wipe it off immediately. Otherwise, any stains
will not be able to be removed.
Appliance exterior
Enamel surfaces Observe the instructions for the surfaces of the
and self-cleaning cooking compartment that follow the table.
surfaces
Glass cover for Hot soapy water:
the interior light- Clean with a dish cloth and then dry with a soft
ing cloth.
If the cooking compartment is heavily soiled, use
oven cleaner.
Door seal Hot soapy water:
Clean with a dish cloth.
Do not remove.
Do not scour.
Stainless steel Stainless steel cleaner:
door cover Observe the manufacturer's instructions.
Do not use stainless steel care products.
Remove the door cover for cleaning.
Stainless steel Stainless steel cleaner:
interior door Observe the manufacturer's instructions.
frame
This can be used to remove discolouration.
Do not use stainless steel care products.
Rails Hot soapy water:
Soak and clean with a dish cloth or brush.
Pull-out system Hot soapy water:
Clean with a dish cloth or a brush.
Do not remove the lubricant while the pull-out rails
are pulled out – it is best to clean them when they
are pushed in. Do not clean in the dishwasher.
Accessories Hot soapy water:
Soak and clean with a dish cloth or brush.
If there are heavy deposits of dirt, use a stainless
steel scouring pad.
--------
Notes
Slight differences in colour on the front of the
■
appliance are caused by the use of different
materials, such as glass, plastic and metal.
Shadows on the door panels, which look like
■
streaks, are caused by reflections made by the
interior lighting.
Enamel is baked on at very high temperatures.This
■
can cause some slight colour variation. This is
normal and does not affect operation.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
This does not impair the anti-corrosion protection.
24

Surfaces in the cooking compartment

The back wall in the cooking compartment is self-
cleaning.You can tell this from the rough surface.
The base, ceiling and side panel are enamelled and
have smooth surfaces.
Cleaning enamel surfaces
Clean the smooth enamel surfaces with a dish cloth
and hot soapy water or a vinegar solution. Then dry with
a soft cloth.
Soften baked-on food residues with a damp cloth and
soapy water. If there are heavy deposits of dirt, use a
stainless steel scouring pad or oven cleaner.
Leave the cooking compartment open to dry after
cleaning.
Cleaning self-cleaning surfaces
The self-cleaning surfaces are coated with a porous,
matte ceramic layer. This coating absorbs and dispels
splashes from baking and roasting while the appliance
is in operation.
If the self-cleaning surfaces no longer clean themselves
sufficiently and dark stains appear, they can be cleaned
using targeted heating.
Making settings
Remove the rails, pull-out shelves, accessories and
ovenware from the cooking compartment beforehand.
Thoroughly clean the smooth enamel surfaces in the
cooking compartment, the inside of the appliance door
and the glass cover on the interior lighting.
Set the 4D hot air type of heating.
1.
Set the maximum temperature.
2.
Start the mode and leave it to run for at least one
3.
hour.
The ceramic coating is regenerated.
When the cooking compartment has cooled down,
remove the brown or white residue with water and a soft
sponge.
During operation, reddish spots form on the
Note:
surfaces. This is not rust, but residues from food. These
spots are not harmful and do not restrict the cleaning
ability of the self-cleaning surfaces.
Caution!
Do not use oven cleaner on the self-cleaning surfaces.
This will damage the surfaces.If oven cleaner does get
onto these surfaces, dab it off immediately using water
and a sponge cloth. Do not rub the surface and do not
use abrasive cleaning aids.