Advertisement
Camcorder operation
Setting the date and time
Before setting the date and time, make sure the
lithium battery
is installed.
(See page 5.)
Example:
Setting the date and time to 2:lO P.M.,
December 24,1998.
Turn the power on, the CAMERA
mode is set
automatically.
Press the DATE and FOCUS LOCK buttons for
about two seconds.
l
The reset time (0:OO:OO) and date (1.1.1997)
are displayed.
Press the DATE button until the desired day (24)
is set, then press the FOCUS LOCK button.
Repeat step 3 to set the month, year and time.
The seconds counter will start counting
from
" 00" when the FOCUS LOCK button
is pressed
after setting the minutes.
Notes
l
The date and time are not displayed in PLAYER
mode.
l
The date and time cannot be set while in
recording mode.
n
Recording the date and time
The date and time will be recorded on the tape as
displayed in the viewfinder.
The date and time will
not be displayed if they have not been set.
Press the DATE button to select the desired display
mode, as shown below.
n
Concerning
the programmed
AE/shutter
speed settings
The optimum
shutter speed is automatically
set
between
l/SO sec. and l/250
sec. according the
brightness of the subject. Accordingly,
AE:lOO,
AE:l SO or AE:250 will be displayed in the
viewfinder.
#-
*
aEE:loo
I I
English
13
Advertisement
