Advertisement
Recording steps
1
Loading a cassette
Eliminate
loose tape inside the cassette by
gently turning the left reel at the bottom of
the cassette with a finger.
Press the EJECT button. The cassette holder will
open.
Insert the cassette fully, with the door toward
the bottom
and the window
facing out.
Gently press on the f@@ indication on the
cassette holder until it clicks into place.
The tape counter is reset to 0:OO:OO.
'
To eject the cassette, press the EJECT button.
To prevent accidental recording on a tape with a
previous recording you wish to keep, set the
erasure-prevention
switch to the red position (6).
r,__,,,,,.,,__,,._,,,,_,.'
2
Recording
1
Press the REC START/STOP
button to start
recording.
(one beep)
2
To stop recording,
press the REC START/STOP
button
again. (two beeps)
When finished recording,
turn the power off.
Notes
If a recording
pause continues for more than 3
minutes, the power is cut to prevent the tape
from being damaged.
For best recording
results, record a well lit
subject, and as much as possible, keep the sun
and other light sources behind you when
recording.
Recording review
If the camcorder is in recording pause mode, press
and release the REW button
once to review, in the
viewfinder,
the last few seconds of the recording.
The camcorder will then automatically
return to
recording pause mode at the exact point where it
previously was.
Note
Do not hold the REW button
as the camcorder will
go into scene search mode.
English
11
Advertisement
