Table of Contents
Advertisement
11 Configure the settings relating to images and audio [Image/Audio]
11 Configure the settings relating to images and
audio [Image/Audio]
The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can be
configured on this page.
The "Image/Audio" page has the [JPEG/H.264] tab, the [Image quality] tab, and the [Audio] tab.
11.1 Configure the settings relating to the image
capture mode [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image/Audio" page. (®page 42, page 44)
[Image capture mode]
Select an image capture mode from the following.
:
SF V 631L
SF V 631L
SPN 631
SPN 631
2 mega pixel [16:9](30fps mode)/2 mega pixel [16:9](60fps mode)/2 mega pixel [4:3](30fps mode)/3 mega pixel
[4:3](30fps mode)*
*Used by super resolution techniques.
•
Default: 2 mega pixel [16:9](30fps mode)
:
SF V 611L
SF V 611L
SPN 611
SPN 611
1.3 mega pixel [16:9](30fps mode)/1.3 mega pixel [16:9](60fps mode)/1.3 mega pixel [4:3](30fps mode)
•
Default: 1.3 mega pixel [16:9](30fps mode)
IMPORTANT
•
The positions of areas may move out of alignment when the "Image capture mode" setting is changed
when the following area settings are configured. Therefore we recommend that you configure each
area setting after configuring the "Image capture mode".
–
mask area (®page 106)
–
privacy zone (®page 116)
–
VMD area (®page 137)
–
VIQS area (®page 118)
–
Cropping outlines (®page 148)
Note
•
When "On" is selected for "VIQS" and the setting value for the aspect ratio is changed from "4:3" to
"16:9", make sure that the VIQS setting value does not exceed the maximum designated range.
88
Operating Instructions
Advertisement
Table of Contents
