Resuming Operation - Panasonic Toughbook CF-28 Series Reference Manual

Standby/Hibernation Functions

Resuming Operation

Rotate the power switch
Windows 98 Windows 2000
When the computer enters either the standby or hibernation mode by the closing
of the LCD panel, it will resume when the LCD panel is opened. If the computer
does not resume when the LCD panel is opened, rotate the power switch.
Windows NT
If the security indicator (
This password has been set in the Setup Utility and is not a Windows NT pass-
word.
CAUTION
After the display returns, the computer needs a short period of time to
reinitialize. This takes about 15 seconds. Do not shut down or restart Win-
dows, or enter either the standby or hibernation mode again during this time,
as this may subsequently cause Windows to operate abnormally.
When operation resumes, serial devices such as a mouse, modem or PC
Cards may not function properly. In such cases, you will need to restart your
computer or reinitialize the individual devices.
Avoid the following until the power is completely turned off when turning off
the computer by using the standby or hibernation functions, or resuming op-
eration from the standby or hibernation.
• Touch the keyboard (excluding password input), touch pad, touchscreen
or power switch.
• Connect or disconnect the AC adaptor.
• Close the display.
Windows 98 Windows 2000
Even when a password has been set in the Setup Utility,
when the computer resumes from the standby or hibernation mode.
(If you want to use the security function when using the standby or hiberna-
tion function, use the Windows password as the following.
Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced],
then add the check mark for [Prompt for password when computer goes off
standby].)
*
Windows 2000 : [Power Options]
) is displayed, your password has been set.
18
does not appear