Panasonic Toughbook CF-28 Series Reference Manual page 23

Security Measures
Setting the User Password
1
Run the Setup Utility
NOTE
When the Supervisor Password has not been set, the User Password can
not be set.
Set the Supervisor Password if you have not done so. (
2
Using either
3
Using either
press Enter
4
<Only when the User Password has been set>
Enter your password at the [Enter Current Password] and then
press Enter
5
Enter your password at the [Enter New Password] and then
press Enter
To disable the User Password
Press only Enter
NOTE
Your password will not be displayed on the screen.
Limit your password to seven characters. Note that there is no distinction
between upper and lower case letters.
Only the alphabet keys or number keys can be used. Note that the space
bar and function keys cannot be used.
6
Re-enter your password at the [Confirm New Password] and
then press Enter
To disable the User Password
Press only Enter
7
At the [Setup Notice], press Enter
8
Press F10 and then select [Yes], then press Enter
CAUTION
Do not input your password while holding down on Shift or Ctrl .
Use only the upper horizontal row of numeric keys to input your pass-
word.
Do not forget your password. If a password is forgotten, you will be un-
able to use your computer. Contact Panasonic Technical Support.
When running the Setup Utility, do not leave your computer even for a
short time.
NOTE
When you do not want the User Password enabled, changed, or disabled
without permission:
1 Using either or
Enter .
2 Using either or
(enabling, changing, disabling)
( page 53)
or , select [Security]
or , select [Set User Password] and then
, select [User Password Protection] and then press
, select [Protected] and then press Enter .
23
page 22)