Drainage; Drain Pump - Miele PW 6080 Vario Operating And Installation Instructions

Drainage

There are two drainage extras for this
machine:
Drain valve
The machine is drained with a
motorized drain valve. A connection
can be made to an on-site floor drain
(gully with an air gap) on an angle.

Drain pump

The wash water is drained using a
pump with a 3 ft (1 m) delivery height*.
Make sure there are no kinks in the
drain hose. The swivel elbow at the
end of the hose can be turned in either
direction, or can be detached if
necessary, with a sharp twist and pull.
Drain hose connection:
1.Connected securely to a plastic drain
pipe with a rubber nipple. There is
no need to use a non-return valve.
2. Connected securely to a standpipe.
3. Connected securely to a floor gully.
If necessary the drain hose can be
extended up to 16' 5" (5 m). The hose
extension can be purchased from your
Miele dealer or Miele.
The drain pump must be replaced for
drain heights over 3 ft (1 m). The
maximum allowable drain height is 5 ft
11 in (1.8 m). A stronger pump for
these heights can be purchased from
your Miele dealer or Miele.
Installation
55