Sony Bravia KDL-52W4500 Operating Instructions Manual page 50

Condition
Changes on the server are not
being applied or displayed
content differs from content
on the server.
Photo and/or music files do
not appear or icons are not
displayed.
The TV cannot be found from
renderer-compatible device
(the controller).
General
The TV turns off
automatically (the TV enters
standby mode).
The TV turns on
automatically.
Some input sources cannot be
selected.
The remote does not function. • Replace the batteries.
HDMI equipment does not
appear on "HDMI Device
List".
You cannot select "Off" in
"Control for HDMI".
Not all channels are tuned for
cable.
The auto tuning procedure
takes a long time.
50
GB
Explanation/Solution
• Sometimes changes are not applied to displays on the TV even though
content has been added and/or deleted on the server. If this happens, go
back up one level and try opening the folder or server again.
Preliminary Check
• Check that the connected device supports DLNA.
• Operations are not guaranteed for all servers. Also, operations differ
depending on the features of the server and the content in question.
• Turn the connected device on.
Check Connections
• Check that the LAN cable and/or AC power cord of the server has not
become disconnected.
Check Settings
• Check that the connected device is registered under "Server Display
Settings" (page 29).
• Check that the server is correctly configured.
• Check that the selected device is connected to the network and can be
accessed.
• If the "IP Address Settings" in "Network" under "Network Settings" is
set to "DHCP", it may take some time to recognise devices if there is no
DHCP server. Execute "Server Diagnostics" (page 30).
Check Connections
• Check that the LAN cable and/or AC power cord of the server has not
become disconnected.
Check Settings
• Check if the "Renderer Function" is activated (page 42).
• Check that the connected device is registered under "Renderer Access
Control" (page 42).
• Check if the "Sleep Timer" is activated, or confirm the "Duration"
setting of "On Timer Settings" (page 36).
• Check if the "On Timer Settings" is activated (page 36).
• Select "Video Labels" and cancel the "Skip" setting for the input source
(page 38).
• Check that your equipment is compatible with control for HDMI.
• If you have connected any audio system that is compatible with control
for HDMI, you cannot select "Off" in this menu. If you want to change
the audio output to the TV speaker, select "TV Speaker" in the
"Speaker" menu (page 38).
• Check the support website for cable provide information.
http://www.sony-asia.com/bravia/flash.html
• If you have connected the VCR to the TV, we recommend inserting a
pre-recorded tape into a VCR before you start auto tuning for fast tuning.
Cancel the auto tuning, and insert a pre-recorded tape into a VCR
connected to the TV. Then select "Auto Start-up" (page 36) to make the
initial set-up again.