Sony Bravia KDL-52W4500 Operating Instructions Manual page 40

Digital Set-up
Digital Tuning
40
GB
Label Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name appears briefly on the
screen when you select the channel.
AFT
Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When "On" is selected, fine tuning adjustments are made
automatically.
LNA Improves the picture quality of the channel (noisy picture)
when the broadcast signal is very weak.
If you cannot see any improvement in the picture quality even
if you set to "On", set this option to "Off" (factory setting).
Audio Filter Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to "Off" (factory setting).
~
• You cannot receive stereo or dual sound when "Low" or
"High" is selected.
Skip Skips unused analogue channels when you press PROG +/–
to select channels. To select channels you have programmed
to skip, use the corresponding number buttons.
Colour System Selects the colour system ("Auto", "PAL", "SECAM")
according to the channel.
Signal Level Displays the signal level for programme currently being
watched.
Digital Auto Tunes in the available digital channels.
Tuning You can retune the TV after moving house, or to search for
newly launched channels.
Programme
Allows you to remove or change the order of digital channels
Sorting stored in the TV.
1
2
3
Press F/f to select the channel you want to remove or
move to a new position.
Remove or change the order of the digital channels as
follows:
To remove the digital channel
Press . After a confirmation message appears, press G
to select "Yes", then press
To change the order of the digital channels
Press g, then press F/f to select the new position for the
channel and press G.
Press RETURN.
.