Troubleshooting - Primus PRI45LM User Manual And Product Specifications

Troubleshooting

Problem
Device does not
function, LED does
not glow
The device does not
cool (plug is inserted,
LED is lit).
The device does
not cool (plug is
inserted, LED fl ashes
and digital display is
blank).
When operating from
the 12/24V socket
(cigarette lighter): The
ignition is on and the
device is not working
and the LED is not lit.
The display shows an
error message (e.g.
"Err1") and the device
does not cool.
Remedy
There is no voltage present in
the 12/24V socket (cigarette
lighter) in your vehicle.
No voltage present in the AC
voltage socket.
The device fuse is defective.
The integrated mains adaptor
is defective.
Defective component.
Battery voltage is too low.
The cigarette lighter socket
is dirty. This results in a poor
electrical contact.
The fuse of the 12/24V plug
has blown.
The vehicle fuse has blown.
The device has switched off
due to an internal fault.
The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
Try using another plug socket.
Replace the device fuse.
This can only be repaired be an
authorised repair centre.
This can only be repaired be an
authorised repair centre.
Test the battery and charge it as
necessary.
If the plug of your cooler becomes
very warm in the cigarette lighter
socket, either the lighter socket must
be cleaned or the plug has not been
assembled correctly.
Replace the fuse in the unit.
Replace the vehicle's 12/24V socket
fuse (usually 15A). Please refer to your
vehicle's operating manual.
This can only be repaired be an
authorised repair centre.