Single Zone and Flexi Zone + Fridge/Freezers Contents GeNeRAl INfORMATION & SAfeTy INSTRucTIONS APPlIANceS ANd AcceSSORIeS GeTTING STARTed OPeRATING yOuR fRIdGe/fReezeR - 12/24V dc OPeRATING yOuR fRIdGe/fReezeR 100-240V Ac TeMPeRATuRe cONTROl SINGle zONe OPeRATION flexI zONe + OPeRATION uSING wITh SOlAR PANel OR GeNeRATOR TIPS ANd SuGGeSTIONS MAINTeNANce &...
General Information & Safety Instructions • Never touch uninsulated cables with bare Read this manual thoroughly before first use, hands. This applies especially to handling even if you are familiar with this type of product. The safety precautions enclosed herein reduce the AC cables.
Page 4
Lid Handle Control Panel 3. Carry Handles Power Input Panel 12V/24V DC Power Cable 6. 240V AC Power Cable Inner Baskets 8. Internal Light Air Flow Vent Note: Images of PRI45LM (Single Zone) and PRI65LDZM (Flexi Zone +) shown www.companionbrands.com.au...
The values indicated on the digital display are related to the middle of the cabinet. The Single Zone Fridge/Freezer is designed to either refrigerate or freeze food. The Flexi Zone Fridge/Freezer can be used as either a fridge or a freezer or both simultaneously.
Single Zone and Flexi Zone + Fridge/Freezers Power Requirements The Fridge/Freezer is designed to operate • The Fridge/Freezer is equipped with an electronic on AC or DC voltage. control system that will prevent polarity reversal. In the event that the battery connection is reversed •...
Operating your Fridge/Freezer with 100/240V AC • Plug the 100-240V AC power cable into the AC POWER socket (as circled below) on the end of the Fridge/Freezer and then connect to a suitable 100-240V AC power source. • The Fridge/Freezer will automatically turn on, there is no requirement to switch the appliance on.
Single Zone and Flexi Zone + Fridge/Freezers Temperature Control When your Fridge/Freezer is first connected to the AC or DC power input the appliance will automatically switch on and the LCD control panel will display the current cabinet temperature, battery monitor and Eco setting as well as the current input voltage.
Single Zone Operation Input Voltage Display Up Button Down Button Power On/Off Button Mode Button Battery Monitor Display Temperature Display Mode Display Power – Off and On Battery Monitor – Setting 1. Press and hold the power button for 2 to 3 1.
Single Zone and Flexi Zone + Fridge/Freezers Flexi Zone + Operation Right Zone Temperature Display Up Button Down Button Power On/Off Button Mode Button Voltage Display Mode Display Button Left Zone Temperature Display Battery Monitor Display Power – Off and On Battery Monitor –...
Page 11
Cabinet Temperature – Setting The temperature may be set independently for each zone in the range -18° to +10°C. Setting the left zone 1. Press the mode button once (1) the temperature display will flash with the current setting. 2. Adjust the temperature by pressing up to increase and down to decrease until the desired temperature is reached...
Single Zone and Flexi Zone + Fridge/Freezers Using with Solar Panel or Generator Using with Solar Panels Using Portable Generators • The power consumption and efficiency of • It is important that the correct generator size your Fridge/Freezer makes it ideal to be used is used with your Fridge/Freezer.
Tips and Suggestions Maintenance & Service • Fresh and frozen foods should not be stored Your Fridge/Freezer will be delivered cleaned from right beside each other in the cabinet. Doing so the factory – you nevertheless should clean prior may cause a fresh food to freeze and/or spoil. to initial use.
Single Zone and Flexi Zone + Fridge/Freezers Troubleshooting Issue Possible Solutions Check the unit is switched ON – Press and hold button for 2 to 3 seconds Check the power source (voltage may be too low) The Fridge/Freezer will not turn on...