Bulbs - BMW R1200RT Rider's Manual

Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 2 so that
front suspension rests securely
on them.
Tighten mounting screw 1.
If the motorcycle is resting
on the center stand: The
motorcycle is raised too far at the
front, the center stand lifts off the
ground and the motorcycle can
tip over to the side.
When raising the vehicle, make
sure that the center stand re-
mains on the ground.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.

Bulbs

Replacing bulbs for low-
beam headlight
The alignment of connec-
tor, spring wire strap and
bulb may differ from that shown
in the following illustrations.
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Remove cover 1 by turning it
counterclockwise to replace
low-beam headlight bulb.
7
131
z