Table of Contents
Advertisement
B. UNPACKING/SETTING UP
Remove protective shipping material (i.e., plastic wrap, and/or optional shipping box) from dryer.
IMPORTANT: Dryer must be transported and handled in an upright position at ALL times.
The dryer can be moved to its final location while still attached to the skid or with the skid removed. To unskid the
dryer, locate and remove the four (4) lag bolts securing the base of the dryer to the wooden skid. Two (2) are at
the rear base, and two (2) are located in the bottom of the lint chamber. To remove the two (2) lag bolts located
in the lint chamber area, remove the lint drawer and the three (3) Phillips head screws securing the lint door in
place.
1. Leveling Dryer
a. To level the dryer, place 4-inch (10.16 cm) square metal shims (refer to the illustration above) or other
suitablematerial under the base pads. It is suggested that the dryer be tilted slightly to the rear.
2. The V-belts are disconnected from the basket (tumbler) drive motor for shipping. Reconnect the V-belts
before starting the dryer.
Advertisement
Table of Contents
