Ringing Patterns; Programming An Auto Dial Number - AT&T MLS-12D Quick Reference

Ringing Patterns

You can tell the type of call coming in by the way the phone rings:
Ring...Ring...Ring...Ring...Ring...Ring...
Ring-BEEP...Ring-BEEP...Ring-BEEP
Ring-BEEP-BEEP...Ring-BEEP-BEEP...
Lights
Red (top) light shows what is happenig at ANOTHER extension.
Green (bottom) light shows what is happening on the line at YOUR extension.
Steady on: Line is busy
Off (off continuously): Line is idle, available for use.
Flash (long on, long off): Call is ringing on the line.
Alternating Red/Green Flash: Appears at both extensions in a
conference or joined call.
Wink (long on, short off): Call is on hold (anyone with line can pick up).
Flutter (short on, short off): Conference call is on hold.
Programming an
Auto Dial Number
MLS-12ONLY
To program an outside number for one-touch dialing:
1. Press [Feature] [0] [0] to enter program mode.
2. Press a programmable Auto Dial button (see diagram of telephone).
3. Dial the telephone number (maximum 20 digits, which can include special
characters, see box below).
To program more buttons or change the programming, repeat steps 2 and 3.
4. Press [Feature] [0] [0] to exit program mode.
To dial: Press the programmed button
Programming Special Characters in a Dial Sequence
To insert a...
Pause (1.5 seconds)
Stop
Touch-Tone Enable
Recall
4
Outside Call
Inside call
Transferred call
Press...
Hold
Mic
Transfer
Spkr