Panasonic AJ-SDa755E Operating Instructions Manual page 72

CONTENTS
RS-232C interface
$ Commands relating to inquiries
<Notes>
O As for the return (completion) message, [ACK] is
first returned when data is received, and the
execution message is subsequently returned. It
is only the execution message which is listed in
this table.
O In the case of commands not listed in the table,
ER001 (invalid command) is returned after [ACK]
has been returned.
VTR
Send command
operation
CTL/TC DATA
[STX] QCD [ETX]
REQUEST
This command is for inquiring about the counter
value.
data = f w gh mm ss ff
f = F
w = S
gh =
CTL mode:
g = SP (20h) : for a plus display
h = 0 – 9
TC mode:
gh = 00 – 23 : hours
mm = 00 – 59 : minutes
ss = 00 – 59 : seconds
ff = 00 – 24 : frames
<Note>
CTL or TC is returned, whichever corresponds to
the front display mode.
STATUS
[STX] QOP [ETX]
REQUEST
This command is for inquiring about the VTR's
operation mode.
222 =
OEJ : EJECT
OFF : FAST FORWARD
OPL : PLAY
ORC : REC
ORW : REWIND
OSP : STOP (including the STANDBY ON)
SRS : (IN/OUT) PREROLL
OBF : STANDBY OFF
OSF : SHTL FORWARD
OSR : SHTL REVERSE
OJG : JOG FORWARD/REVERSE
OSW : VAR FORWARD/REVERSE
EAE : AUTO EDIT
EON : EDIT ON (MANUAL EDIT)
EPV : PREVIEW
ERV : REVIEW
72 (E)
Return (completion)
message
4 5
[STX] CD data [ETX]
– (2Dh) : for a minus display
: hours
4 5
[STX] 222 [ETX]
VTR
Send command
operation
ID (VTR No.)
[STX] QID [ETX]
REQUEST
This command is for inquiring about the VTR
used.
data = AJ-SD755E
Return (completion)
message
4 5
[STX] data [ETX]