Riso RZ390UI User Manual page 54

Advanced Features
5
Press the [
The machine then allows you to enter the number
of copies for the second group.
Repeat steps 2 through 5 to specify the number of
copies and sets for each group.
6
Place an original.
When placing on the Stage Glass.
Place an original on the Stage Glass face down
and align its center with the mark on the left-
hand side of the glass.
When placing in the ADF unit
(option)
Place originals and adjust the Original Guides
to the width of the originals.
52
Automatic Sorting into Groups [Programmed Printing]
Riso Kagaku Technical Training Center Version
] key.
7
Make necessary settings.
Make various settings as necessary.
You can set the following functions:
• Image Processing mode
• Pencil
• Dot Process
• Scanning level
• Enlargement/reduction ratio
• Auto-Process
8
Press the key.
A proof copy is printed.
Check the print result; and if necessary adjust the
print position and other items.
9
Press the key again.
Printing is started with the last programmed
group.
Important!:
• When printing is finished for all groups, the pro-
grammed content is cleared. However, it is not
cleared when "Auto-Process" has been set to
"ON".
Note:
• Printing is stopped each time a routine for one
set is finished. If you do not use the Job Sepa-
rator (option), remove printed copies from the
Paper Recceiving Tray or put separation paper.
• To interrupt printing, press the
the key again to resume printing.
key. Press