Functional Description - Makita BTD200 Instruction Manual

FUNCTIONAL DESCRIPTION
Installing or removing battery cartridge
*Always switch off the tool before inser-
tion or removal of the battery cartridge
To remove the battery cartridge. with-
draw
it
from the tool while sliding the
button on the cartridge
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into
place Always insert
it
all the way until
it
locks in place with
a
little click If you can
see the red part on the upper side of the
button,
it
is not locked completely Insert
it fully until the red part cannot be seen If
-
not, it may accidentally fall out of the tool, causing injury to you or someone around you.
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
easily,
it
Is not being inserted correctly.
Charging
1, Plug the battery charger into your power
source. Two charging lights will flash in
green color repeatedly.
2. Insert the battery cartridge into charger
until it stops adjusting to the guide of
charger. Terminal cover of charger can
be opened with inserting and closed
with pulling out the battery cartridge.
3. When the battery cartridge is inserted,
the charging light color will change from
green to red and charging will begin.
The charging light will keep lighting up lit
steadily during charging.
One red charging light indicates charged condition in 0 - 80% and two red ones indi-
cates 80 - 100%
4 With finish of charge, the charging lights will change from two red ones to two green
ones
The charging time is as follows
Battery B2417 approx 30 minutes
Battery 82430 approx 60 minutes
5 If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last
approximately 24 hours
6 After charging, unplug the charger from the power source
8