Table of Contents
Advertisement
CONNECTING THE JSBW-650 TO EXTERNAL AUDIO DEVICES
You can connect the JSBW-650 audio input to the audio output of your television or
DVD Player. Please see figure below.
NOTE:
1. Make sure that the power is turned off when connecting or disconnecting the other
devices. Make sure that the other devices are connected to the correct terminals.
2. This unit is not magnetically shielded and may cause color distortion on the screen
of some TVs or video monitors. To avoid this, you may need to move the unit further
away from the TV or monitor if unnatural color shifts or image distortion occurs.
CONNECTING THE AC POWER
This unit operates using the included AC adaptor with 22V
) output, and is compatible with standard 120V~ 60Hz AC household power
1. Insert the the DC Plug of the AC Adaptor into the DC IN jack on the back of the unit.
Plug the AC Adaptor into a standard 120V~ 60Hz AC wall outlet.
2. Press the Power On/Standby
the unit. Mode LED Indicator changes color from red to relative mode.
3. Press the Power On/Standby
/SOURCE button on the main unit to turn the unit into standby mode after you
finish listening.
REMOTE CONTROL BATTERY INSTALLATION
The remote control operates on one CR2025 battery (included). To activate the
remote control, remove the insulation tab inserted in the battery compartment. To
remove the tab, pull it in the direction of the arrow in the illustration as shown.
When the operation of the remote control becomes intermittent or unsatisfactory,
replace the original battery with a new 3-volt lithium battery.
Replacing the battery in the remote control:
1.) Press in on the side of the battery holder and pull the holder out of the remote.
GETTING STARTED
button on main unit or remote control to turn on
button on remote control or press and hold the
8
2.5A (center-positive
Hide quick links:
Advertisement
Table of Contents
