Table of Contents
Advertisement
>> To navigate a mix bus to the control surface
Do one of the following:
• •
Scroll to the desired mix bus using the scroll by 1 buttons in the mix
section. Mix bus selection follows the scrolling
• •
Scroll the desired bank of mix buses to the control surface using the
scroll by 8 buttons in the mix section
• •
Select the desired mix bus in the Output Bay and press Align.
>> To select a mix bus
Do one of the following:
• •
Scroll buttons - Scroll to the desired mix bus using the scroll by 1
buttons in the mix section. Mix bus selection follows the scrolling
• •
Touch sensitive control knobs - With the desired mix bus
assigned to the mix section on the control surface, touch/operate its
control knob.
>> To navigate the mix bus processing area to the channel strip
Press the quick access button in the mix section of the desired input fast strip.
This does not aff ect the current population of the output fast zone.
You can select an aux bus or matrix bus processing area on the GUI by clicking
on the title of the desired bank of mix buses in the input channel overview of
the GUI channel strip (see Typical Sends Sections Of The Mixes In The Gui
Channel Strip).
Quick Start Guide
23
Hide quick links:
Advertisement
Table of Contents
