Making A Phone Call; Automatic Redial - Motorola PCS telephone Quick Reference

Making a Phone Call

To make a phone call, your phone must be switched on, unlocked
and have the antenna fully extended.
It will not be possible to make a phone call unless you are in an
area where there is PCS service. When service has been found, a
x
series of rising bars,
There are a number of ways to make a phone call:
• Using the digit keys
• Using automatic redial
• Dialing numbers from the Phone Book
One-Touch Dialing one of the first nine memory locations
Recalling an entry by location number
Using the dedicated Recall Q key
Using the Options Menu
Recalling an entry by name
Using the Smart Button
Using the Options Menu
Recalling one of the last ten numbers called or received
• Calling an embedded number in a message
Your phone contains a Phone Book that can be used to store
A
names and telephone numbers. See
Book?
on page 31 for further details.
18
Making and Receiving Phone Calls
, will show the signal strength.
What is the Phone
Keypad Digits
The simplest method of making a phone call is to enter the
number using the digit keys, then press O.
If you make a mistake, press and release C to remove the
A
last digit. Holding C down will remove the entire number.
The display will show Calling
there is no answer, press O, or close the phone to end the
call.
When the call is answered, the display will change to
for a few seconds, followed by
To end your call, press O or close the phone.

Automatic Redial

If your call attempt does not succeed, the message
be displayed for five seconds. Pressing O at this point will
automatically redial the phone number.
When the call is answered, you will hear a short ring tone.
The maximum number of redial attempts is set by your Service
Provider. If the phone call cannot be connected within this
maximum, the message
Redial Failed
when the call is being made. If
Connected
End Call?
Redial?
will be shown.
will