Pro-Form PERFORMANCE 950 User Manual page 13

13. Set the console assembly on the Left Handrail
(82) and the Right Handrail (83). Be careful not
to pinch any wires. Insert the excess Upright
Wire (not shown) into the Right Handrail.
Attach the console assembly with six #8 x 3/4"
Screws (1) and four 1/4" x 1/2" Screws (9) with
four 1/4" Star Washers (12). Start all ten
Screws, and then tighten each of them.
See steps 5 and 7. Fully tighten the four 3/8" x
4" Screws (7) and the two 3/8" x 1 1/2" Screws
(14).
See step 9. Fully tighten the six 5/16" x 1" Bolts
(4).
14. Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (51) so that the large
barrel and the latch knob are oriented as shown.
Attach the Latch Bracket (6) and Storage Latch
(51) to the Base (95) with two 3/8" x 2" Bolts (8)
and two 3/8" Nuts (10).
Attach the upper end of the Storage Latch (51)
to the Frame (55) with a 3/8" x 2" Bolt (8) and a
3/8" Nut (10). Note: It may be necessary to
move the Frame back and forth to align the
Storage Latch with the Frame.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 24).
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 26 and 27).
13
83
12
9
1
14
10
Latch Knob
13
Console
Assembly
12
1
1
55
8
51
Large
Barrel
6
95
8
10
82
9