Page 1
Model No. PFTL98584 Serial No. Serial Number Decal QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if there are missing or damaged parts, we will guarantee complete satis- faction through direct assistance from our factory.
2. Use the treadmill only as described in this manual. 3. Place the treadmill on a level surface, with at least eight feet of clearance behind it. Do not place the treadmill on any surface that blocks air openings.
Page 4
45 pounds (20 kg) in order to raise, lower, or move the treadmill. 22. Do not change the incline of the treadmill by placing objects under the treadmill. 23. When folding or moving the treadmill, make sure that the storage latch is fully closed.
The model number of the treadmill is PFTL98584. The serial num- ber can be found on a decal attached to the treadmill (see the front cover of this manual for the location).
This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
OPERATION AND ADJUSTMENT THE PERFORMANT LUBE WALKING BELT Your treadmill features a walking belt coated with PERFORMANT LUBE , a high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking plat- form. They will deteriorate the walking belt and cause excessive wear.
As you exercise, four displays will provide continuous exercise feedback. The console also features revolutionary PROFORM CD COACH technology. This breakthrough technology allows the console to play specially-designed CD's...
When you are ready to begin exercising, step onto the foot rails of the treadmill. Find the clip attached to the key and slide the clip onto the waistband of your clothing. Follow the steps below to operate the console.
Page 10
Step onto the foot rails and press the STOP button. Next, change the incline of the treadmill to 1.5%. The incline must be at 1.5% when the treadmill is folded to the storage position or the tread- mill will be damaged.
Page 11
See step 5 on page 9. When the program is completed, remove the key. Make sure that the incline of the treadmill is at 1.5%. The incline must be at 1.5% when the treadmill is folded to the storage position or the treadmill will be damaged.
Page 12
While the unit of measure- ment is displayed, the TIME/ PACE display will show the total number of hours that the treadmill has been used. In addition, the INCLINE/DIS- TANCE display will show the total number of miles that the walking belt has moved.
1. Refer to drawing 2 above. Hold the treadmill with your right hand as shown. Using your left hand, pull the latch knob to the left and hold it. Pivot the treadmill down until the frame is past the pin. Slowly release the latch knob.
2. SYMPTOM: The power turns off during use a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
Page 15
Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is prop- erly tightened. c. If the walking belt still slows when walked on, please call our toll- free Customer Service Department.
Cooling Down End each workout with five to ten minutes of stretching to cool down. This will develop muscle flexibility and will help to prevent post-exercise problems. SUGGESTED STRETCHES The correct form for several basic stretches is shown in the drawings at the right.
PART LISTÑModel No. PFTL98584 To identify parts listed below, refer to the EXPLODED DRAWING attached in the center of this manual. No. Qty. Description Center Track Foot Rail Left Foot Rail Cap Front Roller Adjustment Nut Isolator Bumper Platform Screw...
Page 19
No. Qty. Description Crossbar Washer Console Fastener Upright Endcap 20Ó Wire Harness Magnet Console Base Back 109* Console Assembly Reed Switch Clip Incline Motor Spacer Optic Disk Optic Switch Nut Optic Switch Washer Optic Switch Bolt Optic Switch 2lbs. Hand Weight Roller Guard Head Phone Rear Foot...
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). When ordering parts, please be prepared to give the following information: ¥ The MODEL NUMBER OF THE PRODUCT (PFTL98584). ¥ The NAME OF THE PRODUCT (PROFORM ¥ The SERIAL NUMBER OF THE PRODUCT (see the front cover of this manual).
Need help?
Do you have a question about the PFTL98584 and is the answer not in the manual?
Questions and answers