Programming The Master Power Feature; Volume Control Crossover; Verifying Your Tv Mode Codes - Motorola DSR470 User Manual

Motorola dsr470 digital receiver user guide

Hide thumbs Also See for DSR470:

Table of Contents

Programming the Master Power Feature

If you wish to control the power on/off function of your receiver and TV, and all

connected equipment with a single press of the POWER key on your remote

control, you can enable the remote control's Master Power feature by following

these steps:

•

Press the CBL key on the remote control for at least three seconds or until the

light on the key blinks.

•

Press the POWER key on the remote. The light will remain on steady. Press the

power key a second time, and the light on the remote will blink on and off

briefly, which indicates that the remote has accepted the Master Power

command.

If you wish to cancel the Master Power feature, just repeat the steps outlined

above.

Your remote control unit is programmed from the factory to control the volume of

your television set when you are using the remote control in the CBL mode.

You can verify the accepted programming codes for each mode by following these

steps.

1. Press the TV key for at least three seconds or until the remote control

unit LED blinks.

2. Press the "INFO" key.

3. The LED will blink, indicating the code of your TV, in the following

sequence. For example, if your TV code is for a Tandy brand TV

(code 105), the blink pattern will be:

- Pause>long blink "1;"

- Pause>short blink "0;"

- Pause>long blink, long blink, long blink, long blink, long blink "5."

A zero in the code will always be represented by a short blink.

Table of Contents