Table of Contents
Advertisement
If Your Three-Digit Code is not in the Tables (Scanning)
If you try to program your remote control using the three-digit codes, and the
remote control does not work correctly, you may be able to find a code that works
by using the "scanning" process.
1. Turn on the TV or the VCR-depending upon whether you wish to
program the remote control for your TV or for your VCR.
2. Press the TV key (or VCR key) for at least three seconds or until the
LED blinks.
3. The following steps explain how to "scan" through the TV (or VCR)
codes stored in your remote control using the
not be lit while the
- While pointing the remote control at your TV (or VCR), press the
key to scan upward to the next code. (Use the
previous code.)
- If the transmitted code is the correct one, your TV (or VCR) will turn
off, responding as if its POWER key were pressed.
- If your TV (or VCR) does not respond, depress the
next code. When your TV (or VCR) turns on or off as a result of the
transmitted code, you will know that you have found the correct code.
- When you have found the correct code (power to your TV or VCR is
toggled on or off), press the ENTER key. This will store the
manufacturer's code. The LED will then flash rapidly several times and
turn off.
NOTE: If your TV is not listed in the tables and/or the codes for your brand are not
accepted by the remote, you will need to use the remote originally manufactured
for your unit.
Programming the Master Power Feature
If you wish to control the power on/off function of your satellite receiver, VCR,
TV, and all connected equipment with a single press of the POWER key on your
remote control, you can enable (or disable) the remote control's Master Power
feature by following these steps:
•
Press the SAT key on the remote control for at least three seconds or until the
light on the key blinks.
•
Press the POWER key on the remote. The light will remain on steady. Press the
power key a second time, and the light on the remote will blink on and off
briefly, which indicates that the remote has accepted the Master Power
command.
DSR405 User Guide
k eys are depressed.
v
Using Your Remote
k eys. (The LED will
v
k ey to return to the
6
k ey to try the
5
5
5
Advertisement
Table of Contents
