Center Pillar Installation - Ford 2006 Escape J87R Bodyshop Manual

BODY STRUCTURE [PANEL REPLACEMENT]
CENTER PILLAR INSTALLATION[PANEL REPLACEMENT]
1. When joining the new and old parts, temporary install and fit the new part in position, measure each dimension
according to the body dimension, the adjust the position to align it to the standard dimensions.
2. Drill holes for plug welds before installing new parts.
Note
• In areas where the outer, reinforcement, inner, and other parts are in 3-4 layers, drill holes for plug welds
in all but the innermost panel.
3. After installing and temporarily install the inner, reinforcement and the side sill reinforcement, plug weld during
installation of the outer.
4. After temporarily installing new parts, make sure the related parts fit properly.
50mm {1.96in}
50mm {1.96in}
CUT-AND-JOIN LOCATION FOR THE
CENTER PILLAR (OUTER)
25mm
{0.98in}
CUT-AND-JOIN LOCATION FOR THE
SIDE SILL REINFORCEMENT
End Of Sie
BM: SIDE SILL PANEL
CUT-AND-JOIN LOCATION FOR THE
CENTER PILLAR (OUTER)
150mm
{5.90in}
CUT-AND-JOIN LOCATION FOR THE
CENTER PILLAR (INNER)
CUT-AND-JOIN LOCATION FOR THE
CENTER PILLAR REINFORCEMENT
19
19
4
2
3
14
CUT-AND-JOIN LOCATION FOR THE
CENTER PILLAR (OUTER)
BOTTOM SIDE 3
80mm
40mm {1.57in}
{3.14in}
6
25mm
{0.98in}
id098008744000
80B
140mm
{5.51in}
INSULATOR
BUE0980B021
09-80B–19