Ford 2006 Escape J87R Bodyshop Manual page 15

Spot Welding Notes
• The shape of the spot welder tip is D=(2×t)+3. If
the upper panel thickness is different from that of
the under panel, adjust to the thinner one.
• Because the weld strength is affected by the
shape of the spot welder tip, the optimum
condition of the tip should always be maintained.
• Spot welds should be made at points other than
the originally welded points.
• Before spot welding, make a trial weld using the
same material as the body panel to check the
weld strength.
GENERAL INFORMATION
70 - 120°
D
t
acxuub00000054
acxuub00000070
Test piece method
Nugget diameter
:4/5 of tip
acxuub00000071
00-00–11
00