Error Messages - Panasonic KX-TG6611NZ Operating Instructions Manual

TG6611_6621NZ(e).book Page 41 Monday, February 14, 2011 8:43 AM

Error messages

Display message Cause/solution
L The handset has lost communication with the base unit. Move
Base no power
or
No link. Reconnect
L Unplug the base unit's AC adaptor to reset the unit.
AC adaptor.
or
L The handset's registration may have been cancelled. Re-
No link.
L When "No link." is displayed during a power failure, place
L The supplied telephone line cord has not been connected yet
Check Phone Line
*1
L Recording was too short. Try again.
Error
L Phonebook copy failed (page 21). Confirm the other handset
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unwanted entries (page
Memory Full
L Message memory is full. Erase unwanted messages (page
L The call barred list memory is full. Erase unwanted entries
L A wrong type of battery such as Alkaline or Manganese was
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you receive
You must first
subscribe to Caller
ID.
*1 KX-TG6621/KX-TG6622
closer to the base unit and try again.
Reconnect the adaptor and try again.
register the handset (page 28).
a handset on the base unit to supply power to the base unit.
or not connected properly. Check the connections (page 9).
(the receiver) is in standby mode and try again.
unwanted phonebook entries from the other handset (the
receiver) and try again.
20).
*1
33, 34).
(page 27).
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Useful Information
41