Windsor Chariot 2 iVac 24 AVT Operating Instructions Manual page 39

To Repair or Replace Vacuum Motor
1. Remove four (4) screws from top of control panel.
2. Tip control panel back from console to expose
vacuum motor wires.
3. Disconnect electrical connector from the vacuum
motor.
4. Replace one screw to secure control panel to
console.
5. Open console.
6. Remove the two (2) nuts from vac motor bracket,
as shown below.
7. Remove three (3) screws that secure vacuum
motor assembly in place. Remove vacuum motor
assembly, as shown below.
VACUUM ASSEMBLY
MOUNTING SCREWS (3)
VACUUM MOTOR
BRACKET
86374850 Chariot iVac 24
8. Remove move three (3) screws that secure
vacuum motor. Replace motor.
9. Reverse steps to install.
NOTE: If vacuum motor is not mounted as shown,
vacuum may not seal properly, resulting in poor
performance.
Vacuum Motor Carbon Brushes
Carbon
Brushes
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Inportant:
These brushes wear quicker as the length shortens due to
increased heat. Spring inside brush housing will damage
motor if brushes are allowed to wear away completely.
both carbon brushes when either is less tan 3/8" (9.5mm)
long.
Maintenance
1.18
VACUUM MOUNTING
SCREWS (3)
End Cap
3
[9.5mm]
8
39