Errors While Scanning; Symbology Parameter Defaults - Symbol DIGITAL DS6708 Product Reference Manual

13 - 2 Symbol DS6708 Digital Scanner Product Reference Guide

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Symbology Parameter Defaults

Table 13-1 lists the defaults for all symbologies parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan configuration program (see
NOTE See
parameters.
Parameter Defaults
Table 13-1
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8/JAN 8
EAN-13/JAN 13
Bookland EAN
Decode UPC/EAN/JAN Supplementals (2 and 5 digits)
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
UPC/EAN/JAN Supplemental Redundancy
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Transmit UPC-E1 Check Digit
UPC-A Preamble
UPC-E Preamble
UPC-E1 Preamble
Convert UPC-E to A
Appendix A, Standard Default Parameters
Parameter
Set Default Parameter on page
Chapter 12,
for all user preferences, hosts, and miscellaneous default
Parameter
Default
Number
01h Enable
02h Enable
0Ch Disable
04h Enable
03h Enable
53h Disable
10h Ignore
F1h 43h
F1h 44h
50h 10
28h Enable
29h Enable
2Ah Enable
22h System Character
23h System Character
24h System Character
25h Disable
4-4.
123Scan).
Page
Number
13-7
13-7
13-8
13-8
13-9
13-9
13-11
13-13
13-13
13-14
13-14
13-15
13-16
13-16
13-18
13-19