Decode Aiming Pattern
Parameter # F0h, 32h
This parameter only applies in Decode Mode. Select Enable Decode Aiming Pattern to project the aiming pattern
during bar code capture, or Disable Decode Aiming Pattern to turn the aiming pattern off.
NOTE With
Picklist Mode on page 4-10
Aiming Pattern is disabled.
*
Enable Decode Aiming Pattern
(02h)
Low Light Enhancement
Parameter # F1h, 64h
In Scanstand mode, selecting Enable Low Light Enhancement causes illumination to remain on at a low level in
low lighting conditions. Select Disable Low Light Enhancement to prevent illumination from remaining on under
these conditions.
Enable Low Light Enhancement
(01h)
enabled, the decode aiming pattern flashes even when the Decode
Disable Decode Aiming Pattern
*Disable Low Light Enhancement
Decoding Preferences
(00h)
(00h)
5 - 5