4 - 2
DS6707 Digital Imager Scanner Product Reference Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning
several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences and Miscellaneous Options - Parameter Defaults
Table 4-4
lists defaults for user preferences parameters. There are two ways to change the default values:
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
•
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers are shown in
this chapter below the parameter title, and options are shown in parenthesis beneath the accompanying
bar codes. See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for
changing parameters using this method.
See
NOTE
and miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-4
Parameter
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Decode Session Timeout
Appendix A, Standard Default Parameters
Parameter
Number
ECh
91h
8Ch
80h
92h
8Ah
F0h 92h
88h
Beeper Tone on page
4-5. The digital imager
*Set All Defaults
bar code on page 4-4.
for all user preferences, hosts, symbologies,
Default
Number
All Defaults
4-4
Enable
4-4
Medium
4-5
High
4-6
Continuous On
4-6
1 Minute
4-7
Auto Aim
4-8
Disabled Always
4-9
9.9 Sec
4-10
Page