Before Using The Terminal; Part Names And Functions - Docomo F-03D Instruction Manual

Before using the terminal

Part names and functions

a
a
b
c
d
e
f
b
c
i
j
k
l
m
n
o
<Functions>
a Stereo earphone jack
b Earpiece
c Proximity sensor
Prevents the erroneous operation of the touch panel
during a call.
* Putting a protective sheet or seal on the proximity sensor may
d Light sensor
Sense ambient brightness to automatically adjust
brightness of the display backlight and turn on the key
illumination when pressing a key.
* If the sensor is covered, detection may not be performed
g
e Display (Touch panel)
f Microphone
g In-camera
h Illumination (Key light, camera ring light)
* Key center light and camera ring light turns on and blink in
* Color of light or flash may be different according to the
h
i 1Seg antenna
* Extend when watching 1Seg.
j Camera light (Flash)
d
k Out-camera
l Infrared data port
p
m Back cover
q
* To access docomo mini UIM card slot and the microSD card
r
e
* Rubber gasket is attached on the rear side of the back cover to
s
h
n Strap hole
o FOMA antenna
* The antenna is built-in the terminal. Covering around the
t
p Bluetooth/Wi-Fi antenna section
* The antenna is built-in the terminal. Covering around the
q GPS antenna
* The antenna is built-in the terminal. Covering around the
u
23
cause erroneous operation.
properly.
several colors.
illumination settings.
slot, remove the back cover and the battery pack.
resist water .
antenna by the hand may affect the quality.
antenna by the hand may affect the quality.
antenna by the hand may affect the quality.
Before using the terminal