Cirrus Design
SR22
Wing Fire In Flight
1. Pitot Heat Switch ..................................................................... OFF
2. Navigation Light Switch............................................................ OFF
3. Landing Light ........................................................................... OFF
4. Strobe Light Switch .................................................................. OFF
5. If possible, side slip to keep flames away from fuel tank and cabin.
6. Land as soon as possible.
Amplification
Putting the airplane into a dive may blow out the fire. Do not
exceed V
NE
Engine Fire During Start
1. Mixture ..............................................................................CUTOFF
2. Fuel Pump ............................................................................... OFF
3. Fuel Selector............................................................................ OFF
4. Power Lever ..................................................................FORWARD
5. Starter ................................................................................ CRANK
6. If flames persist, perform
Ground
and
Amplification
A fire during engine start may be caused by fuel igniting in the fuel
induction system. If this occurs, attempt to draw the fire back into the
engine by continuing to crank the engine.
P/N 13772-004
P/N 13772-004
Original Issue
• Caution •
during the dive.
Emergency Ground Egress
Emergency Engine Shutdown On
Checklists.
Section 3
Emergency Procedures
3-13
3-13