Cirrus SR22 Pilot's Operating Handbook And Flight Manual page 319

Cirrus Design
SR22 / SR22T
INITIAL INSTALLATION
Clip strap to triangular loop as shown in
Detail A. Route strap over headrest, down
the back of the seat, and forward between
the cushion and seat back. Clip strap to
lower triangular loop. Tighten strap with
cinch.
Note Prior to installing bottle the
first time, the horizontal straps will
be disassembled in order to pass
the loose ends through the loops
on the Tuff Pack Bag. Be sure to
note the strap routing through the
buckle and cinch during
disassembly to aid in reassembly.
Route loose end of strap around
the seat back, through rectangular
loops on forward side of bottle, as
shown in Detail B, through the male
buckle half, and through the cinch,
as shown in Detail C. Insert male
buckle half into female buckle half
and tighten strap at cinch.
Same as step 2.
CLIP
STRAP
P/N 13772-109
Revision 02: 01-06-10
LOOP
LOOP
LOOP
Figure - 1
Oxygen Bottle Mounting
TUFF PACK BAG
MALE
BUCKLE
CINCH
Section 9
Supplements
OXYGEN BOTTLE
FEMALE
BUCKLE
SR20_FM09_1081
5 of 6