Cirrus SR22 Pilot's Operating Handbook And Flight Manual page 353

Cirrus Design
SR22 / SR22T
Section 2 - Limitations
No Change.
Section 3 - Emergency Procedures
Forced Landing
Before performing a forced landing activate the ELT transmitter
manually by turning the ELT remote switch to the 'ON'-position.
Immediately after a forced landing, perform the following procedure:
The ELT Remote Switch and Control Panel Indicator could be
inoperative in the event of a forced landing. If inoperative, the
inertia "G" switch will activate automatically. However, to turn
the ELT OFF and ON will require manual switching of the main
control switch located on the ELT unit.
1. ELT Remote Switch .........................................................Verify ON
• Switch the ELT Remote Switch ON even if the red LED
annunciator is flashing.
• If airplane radio operable and can be safety used (no threat of
fire or explosion), turn radio ON and select 121.5 MHz. If the
ELT can be heard transmitting, it is working properly.
2. Battery Power ..................................................................Conserve
• Do not use radio transceiver until rescue aircraft is sighted.
After sighting rescue aircraft:
3. ELT Remote Switch ................................................ "ARM" position
• Attempt contact with rescue aircraft with the radio transceiver
set to a frequency of 121.5 MHz. If no contact is established,
switch the panel mounted switch to the 'ON'-position
immediately.
P/N 13772-131
Revision 02: 01-06-10
• Note •
(Continued on following page)
to prevent radio interference.
Section 9
Supplements
3 of 8