Sony sl-hf600 Operating Instructions Manual page 71

8
Press EDIT MARK
EDlT
T
Lights.
I - ,
O M 0 0 0 0 6 0 0 0 3 7 0 9
@a
u ~ u u . 3 7
LAP
o
00 37 10
The ending point
is now memorized.
9
a
ASSEM START
-
END
0 0 0 B b S b 0 0 0 3 7 0 9
LAP
o
00 37
10
For other scenes, repeat steps 4,6,7 and 8 to set the
starting and ending points in the memory. Up to 8 scenes
can be preset.
Ex. When 6 scenes have been preset
Shows the total duration
of
all
the preset scenes.
9 On the VCR for editing, locate the point on the tape
where you want to start editing and set the VCR to
playback
pause mode
(or
recording pause.mode
when the VCR for editing is not SL-HF1000).
When editing
from
the beginning of the tape, set the
starting point where the tape has advanced for 10
seconds or more from the beginning.
10
Press EDlT START on the VCR for playback.
Automatic assemble editing will start.
The scenes will be edited automatically in the
preset order.
EDlT
START
%
When all the scenes
have been
edited, both VCRs will be
set to playback pause mode.
To
@tap
the autmatk amamble
editing
monmtadly, press
IIIDM PAUSUSTILL To resume the editing, press EDIT
START.
To change the prevlwsly
m t
ltenrs during prr#ietthrg,
press BACK until the desired item blinks, and then locate
the correct point and press EDIT MARK.
To cancel
the
aubmatk
assemMe
eclitlng mode, press
EDIT ASSEMBLE. The memory of the preset scenes will be
erased.
Note
Automatic assemble editing is not possible for the two
scenes between which searching time takes more than 8
minutes.
FOR ACCURATE PRESEITING
OF
EDITING
. I N =
The preset starting and ending points may shift
slightly after the tape has been advanced rapidly,
stopped and rewound repeatedly for locating those
points.
To minimize the shift, proceed as follows:
1
Before presetting the starting point of scene 1,
press COUNTER RESET to register that point as
counter zero.
2
Preset all the required scenes.
3
Locate the starting point of scene 1 again,
accurately to the extent of a frame, by observing
the playback picture.
4 Press COUNTER RESET.
5
Press
EDIT START to start the automatic assemble
editing.
If you stop the tape with STOP when presetting an
editing point, the editing point will be shifted. To
correct the shift, locate the starting polnt of scene 1
again and press COUNTER RESIT.
i