Sony sl-hf600 Operating Instructions Manual page 44

BEFORE THE TIMER-ACTNATED RECORDING
the pmettings of
your
timer-actlvated d n g s
STARTS
recording of program 2 will begin before program 1 is
Tocheckthetimersethgs
Press CHECWPAGE.
Every tlme you press CHECWPAGE, each program will be
displayed in the display window.
To change the
settlngs
1
Press TIMER REC. The indicator goes off.
2
Fwss CHECWPAGE to select the program to be
changed.
3 Press TIMER SET.
4
Fwss NEXT until the Item to be changed blinks.
5
Change the setting with + I - or JOG.
6
Press NEXT
so that the tape counter and the current
time appear in the display window.
7
Press TIMER REC again to reactivate the timer.
To
erase
the
memory of
a particular
program
1
Press TIMER REC. The
l m l
indicator goes off.
2
Press CHECWPAGE to select the program to be erased.
3
Press CLEAR. The memory of the program will be
eliminated.
4
If other programs have been preset for recording, press
TIMER REC again to reactivate the timer.
DURING RECORDING
To stop dudng the timer recording
Press TIMER REC. The recording will stop and the power
will be turned off.
Whenthetapeendsdwlngtimermcoding
The tape
stops 6ut the
tape
will not be rewound.
The STOP and I l l - PAUSEISTILL buttons do not
function during a timer recordlng.
will be cut
off
Program 1
4
1 1 : ~ pm
10:00 pm program
2
1 - u
10:45 pm
1215 am
If the turnan time of
two
programs are the same
The recording of the program having the lower program
number will be made. The memory of the program having
the higher number will be cleared.
10:W pm
Program 1
1 - h
11:W pm
Recording will not be made.
If the turnan tlme of one program is the same as the
twn.
o f f time of another program
When a timer recording starts, the unit is
set
to recording
pause mode
6
seconds before the preset turnan time. The
pause mode is released exactly at the preset turn-on time
and recording starts approximately
1
second after.
Therefore, the end of the first program will not be recorded
for 6 seconds. Both recordings, however, will be made
smoothly.
If a
power
intermptlon
occurs before
a timer recording
The clock will stop and "AM 1 2 W will blink. This means
that the memory of the timer programs has been
completely erasd. Reset the clock and timer programs.
4
A short power interruption of less than approximately 10
SPECIFIC NOTES ON TIMI ACTIVATED
minutes will not affect the memory. The clock will show
RECORDINGS
the correct time and the timer programs will be performed.
Troubles
when
TIMER REC
is
prerssed
If the power was Interrupted d u n g a timer recording or
quick timer mcoding
Recording will stop and the power will
be
turned off. If the
The cassette will be
The cassette inserted
interruption was less than approximately 10 minutes, the
ejected automatically. has the safety tab recording will resume.
removed.
No cassette is inserted.
I ]
indicator The tape is at its end.
disappears.
current time.