Sony sl-hf600 Operating Instructions Manual page 32

back on
another I.ecorder horn the very beginning of
the
tape, run the tape for about 15 seconds before starting
recording. Otherwise you may miss the starting point
-
NOTE
SUPER BETA BUlTON
For d n g
Set to ON to make high picture quality recordings.
Set to OFF if you intend to play back the tape on a
nonSuper8eta VCR A tape recorded with the SUPER
BETA button set to ON may cause some over-
modulation noise when played back on a non-
SuperBeta VCR.
For playback
Normally set to the position in whlch the tape was
recorded.
Set to ON if the tape was recorded in the WIs mode.
Set to OFF if the tape was recoded in the IBI mode,
or if the tape was recorded on a nonSuperBeta VCR.
WIS SHB (
ItlI s
SUPER HI-BAND) SWCTCH
This switch is effective only for recording in WIs mode.
WIs recording produces a highquality picture as in
SupwBeta recording regardless of the SUPER BETA
switch position.
To obtain a better quality picture in IBIS recording, set
the WIs SHB switch to ON. A 6. 0 MHz super hi-band
recording will be made.
If you intend to play back the tape on another VCR
without the lBIs SHB switch, keep the switch at OFF.
To assure the high quality of the super hi-band
recording, use of highquality tapes such as Sony P R W
type is recommended.
You can decide the starting point for recording while
watching the picture.
1
Play back the tape and locate the point where you wish
to start recording on the tape.
2
Press I I I b t 4 PAUSEISTILL to stop the tape where you
wish to start recording.
3
Slide REC to the right. The recorder will enter
recording pause mode.
4
Press IIl~l4 PAUSUSTILL at the desired point to
release the pause mode. Recording will begin.
1 Set the VCR to recording pause mode.
2 Press
b
PLAY. The VCR will enter playback pause
mode.
3
Locate the desired point where you wish to start
recording by turning the JOG dial. (See page 36)
4
Slide REC to the right. The VCR will enter recording
pause mode.
5
Press lllM PAUSEISTILL at the desired point.
Recording will begin.