Unoccupied Mode - Panasonic CS-KS30NKU Technical & Service Manual

7. UNOCCUPIED Mode

Unoccupied mode is used to prevent the room temperature from
increasing too much when no one is in the room, and operate
automatically to save energy.
Press the UNOCCUPIED button.
The mark appears in the display.
To release the unoccupied function, press the UNOCCUPIED button
again.
Unoccupied Indication
Unoccupied Unoccupied
Function Indication
OFF no display The unoccupied function is not set.
The unoccupied function is now
being set, and under Cooling
operation.
flashing
ON
Although the unoccupied function is
set, not under Cooling operation.
lighting
NOTE
Even if Unoccupied Mode is ON, it will be disabled if the air
conditioner is in operation.
• Unoccupied Function can be set and released through all
operational modes, regardless of whether the air conditioner is
operating or not.
• If the Unoccupied Function is ON and the remote controller is used
to turn the air conditioner OFF (including OFF TIMER), the air
conditioner will turn off, but depending on the room temperature,
Cooling Operation will automatically begin.
• When the Unoccupied Function is in operation and the ON/OFF
operation button is pressed, operation will restart based on the
settings input before the air conditioner was turned off.
In Cooling Mode: (
(1) When the room temperature rises above 89°F, Cooling
(2) When the room temperature drops below 82°F, Cooling
The above actions will repeat so that the room temperature is
maintained at about 86°F.
• Unoccupied Mode triggers Cooling Operation in response to the
room temperature, but when this happens, the remote controller
will continue to display the Operation mode set by the user.
• If the room temperature rapidly changes, the room temperature
may get over the upper or lower limit when the unoccupied function
is activated.
NOTE
• The remote controller should be used in the location specified in
"REMOTE CONTROLLER INSTALLATION POSITION" on page 8.
• The air conditioner's stop order (stated in (2) / above) is valid only
Status
when the unoccupied function is operated.
)
Operation will begin.
Operation will stop.
Room
Temperature (°F)
(1)
89
86
82
Cooling
starts
(2)
Time
Cooling
stops
11