High Power Mode; Unoccupied Mode - Panasonic CS-KE30NKU Technical & Service Manual

7. HIGH POWER Mode

HIGH POWER mode can be used to increase the output of the
indoor unit for all operation modes except automatic operation.
Press the HIGH POWER button while unit is operating.
The mark appears in the display.
To cancel, press HIGH POWER button again.
• When the HIGH POWER button is pressed, the unit operates at
maximum output for 30 minutes, regardless of the desired
temperature. The fan speed is 1 step above "High".
• HIGH POWER Mode cannot be used when the operation mode is
in Automatic Operation.
• QUIET Mode and HIGH POWER Mode cannot be used at the
same time.
NOTE
• Pressing the MODE selector button cancels HIGH POWER mode.
• When set to High fan speed during heating operation, the fan runs
at High fan speed even though the
• Depending on the operating conditions, the fan speed may be
increased by a small amount only.
mark is displayed.

8. UNOCCUPIED Mode

Unoccupied mode is used to prevent the room temperature from
decreasing too much (or increasing too much) when no one is in the
room, and operates automatically to save energy.
Press the UNOCCUPIED button.
The mark appears in the display.
To release the unoccupied function, press the UNOCCUPIED button
again.
Unoccupied Indication
Unoccupied Unoccupied
Function Indication
OFF no display The unoccupied function is not set.
The unoccupied function is now
being set, and under Heating (or
Cooling) operation.
flashing
ON
Although the unoccupied function is
set, not under Heating (or Cooling)
operation.
lighting
NOTE
Even if Unoccupied Mode is ON, it will be disabled if the air
conditioner is in operation.
• Unoccupied Function can be set and released through all
operational modes, regardless of whether the air conditioner is
operating or not.
• If the Unoccupied Function is ON and the remote controller is used
to turn the air conditioner OFF (including OFF TIMER), the air
conditioner will turn off, but depending on the room temperature,
Heating or Cooling Operation will automatically begin.
• When the Unoccupied Function is in operation and the ON/OFF
operation button is pressed, operation will restart based on the
settings input before the air conditioner was turned off.
Status
11