Operation And Important Riding Points; Starting A Cold Engine - Yamaha wr450fb Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
1
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
2
WARNING
3
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
4
or injury.
5
6
7
8
9
EAU15951
TIP
This model is equipped with a lean an-
gle sensor to stop the engine in case of
a turnover. To start the engine after a
EWA10271
turnover, be sure to push the main
switch to "OFF" and then to "ON". Fail-
ing to do so will prevent the engine from
starting even though the engine will
crank when pushing the start switch.
EAU53110

Starting a cold engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:


1. Push the main swtch to "ON" and
NOTICE
If a warning light does not come on
initially when the main switch is
pushed to "ON", or if a warning light
remains on, see page 4-1 for the cor-
responding warning light circuit
check.
2. Shift the transmission into the neu-
6-1
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
See page 4-19 for more informa-
tion.
make sure that the engine stop
switch is set to " ".
The following warning light should
come on for a few seconds, then
go off.

Fuel level warning light

Engine trouble warning light
EAU52903
ECA17781