Yamaha wr450fb Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
ton together again.
TIP
The stopwatch will continue counting
1
when the vehicle is stopped. To stop
and/or resume counting, repeat steps 3
2
and 4.
3
Measurement mode (for calibrating
the distance-compensation tripme-
ter's reading)
4
The distance-compensation tripmeter
is a feature intended to provide a more
5
accurate tripmeter reading for enduro
riding. Calibrating this meter in accor-
6
dance with the distances specified on
the enduro course map will help famil-
iarize the rider with the course. In addi-
7
tion, calibrating the meter may also be
necessary when using tire, wheel,
8
chain sprocket sizes, etc. other than
specified. For further information con-
9
cerning the use of this meter, please
consult your nearby Yamaha dealer.
Calibrate the distance-compensation
tripmeter as follows.
To increase the reading, push the
"SLCT 1" button. To decrease the read-
ing, push the "SLCT 2" button. Pushing
and holding either button will increase
or decrease the reading continuously
until the button is released.
TIP
Calibrating the reading of the dis-
tance-compensation tripmeter is possi-
ble regardless of the
operation.
Resetting the distance-compensa-
tion tripmeter or the distance-com-
pensation tripmeter in combination
with the stopwatch
TIP
Resetting can be made only to the dis-
tance-compensation tripmeter or to the
distance-compensation tripmeter
combination with the stopwatch.
Resetting the distance-compensation
tripmeter
1. Check that the stopwatch mea-
surement is in operation.
2. Reset the distance-compensation
tripmeter to zero by pushing the
"RST" button for at least two sec-
onds.
4-6
Resetting the distance-compensation
tripmeter in combination with the stop-
watch
1. Stop the stopwatch.
2. Reset the distance-compensation
tripmeter and the stopwatch to
zero by pushing the "RST" button
stopwatch
for at least two seconds.
in