Table of Contents
Advertisement
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and discharged.
Please note
◆
Base station and handset package: The handset is pre-registered with the base station. If you have purchased
a model with multiple handsets, all handsets will already be registered with the base station. You do not need
to register the handset again.
However, if a handset is not registered with the base station (Register HS or Put into base is displayed), please
register the handset manually (
Handset and charging cradle package: please register the handset manually (
◆
After the first battery charge and discharge, you may place your handset in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the batteries from the handset and rein-
sert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for technical reasons.
Changing the display language
Change the display language if you do not understand the language currently set:
¤
421
§Menu§
¤
(press the keys one after the other)
Press and hold the end call key
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and so that the alarm can be
used.
¤
¤
q
§Menu§
Settings
¤
¤
¤
~
§OK§
Time
(enter hours and minutes in 4-digit format)
¤
a
(press and hold to return to idle status).
You can move the position of an entry to the left or right by pressing the control key left or right
Please note
If your phone receives the date and time during calling line display (e.g., via your network provider, a router or
¤
PABXs), you can specify whether this data should be copied to your phone:
Press the key sequence:
The following is displayed; the current setting flashes:
¤
Press one of the following keys to specify, when this data should be copied to your phone:
Q
Never
1
or
Once, in case the date/time is not set on your phone
2
or
Always
¤
Your selection is displayed (e.g., 2):
Press the display key
6 h
¢
page 13).
a
to return to idle status.
¤
¤
§OK§
§OK§
Date/Time
¤
P#Q5#MI
§Menu§
973 SET: [2]
§OK§
.
5
¤
Charge the handset in the base station/charging cradle
for 6 hours.
Please note
The handset must only be placed in the designated
Gigaset base station or charging cradle.
¤
After charging, remove the handset from the base sta-
tion/charging cradle and only replace it when the batter-
ies are fully discharged.
¤
q
(select language)
¤
¤
~
Date
(enter the day, month and year in 6-digit format)
¤
§OK§
(display message: Saved)
973 SET: [ 0 ]
¢
page 13).
¤
‰
§OK§
(
= current language)
r
.
Advertisement
Table of Contents
