Maintenance; Dirt Cup; Filters - Hoover UH70403 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

4. MaintenanCe

Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.

dirt CuP:

when to empty
4.1 Empty the dirt cup before the dirt cup reaches
the max line (A). Place the vacuum in the upright
position before removing the dirt cup.
CAUTION
!
!
To reduce the risk of injury from moving
parts, unplug vacuum before servicing. Do not
use vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or
cornstarch, may seal the filter and cause a
reduction in performance. When using the
vacuum for this type of dust, empty the cup
and clean the filters often.
dirt CuP:
how to empty
4.2 Press dirt cup release button and pivot cup out.
4.3 Hold dirt cup over trash receptacle, push dirt cup
door release lever (A) to open dirt cup door (B).
Close dirt cup door (B). Press firmly to secure.
4.4 Place bottom of dirt cup into vacuum body
first. Pivot dirt cup into vacuum. Press down on the
dirt cup release button to secure into place.

filters:

when to Clean
To maintain optimal performance, filters should be
cleaned every two months under normal use.
CAUTION
!
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
rinsable filter: how to Clean
Remove dirt cup as described in Fig. 4.2.
4.5 Twist the dirt cup lid to open.
4.6 Pull tab to remove rinsable filter.
Rinse with water for two minutes or until water runs
clear. Then squeeze out excess water. Allow 24
hours for filter to dry completely.
Replace filter, tab side out.
Close lid securely by twisting dirt cup lid until it clicks
as shown in Fig. 4.5.
Replace dirt cup as described in Fig 4.4.
4.1
4.2
A
4.3
4.4
b
A
4.6
4.5
rinsable filter: what to buy
When used and maintained properly, your Rinsable
Filter should not need replacement within the
warranty period. If desired, additional filter is
available. Ask for Hoover
Part No. 303903001.
®
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
9

Advertisement

Table of Contents
loading

Table of Contents