Specifications; Ec Declaration Of Conformity - Makita DA4000LR Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Model
Steel
Wood
High
)
Low
Overall length
Net weight
Safety class
equipment and
) : 80 dB(A)
pA
END201-5
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
its
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENE032-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENF002-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only

EC Declaration of Conformity

We Makita
ENG104-2
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Angle Drill
Model No./ Type: DA4000LR
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2
DA4000LR
13 mm
38 mm
0 - 900
0 - 400
413 mm
4.0 kg
/II
) : 2.5 m/s
h,D
2
Corporation as the
ENG202-3
2
or less
ENG901-1
ENH101-13
responsible