Makita DA4000LR Instruction Manual page 6

1
2
004657
CAUTION:
The drill chuck and the bolt are assembled each
•
other. Turn the bolt counterclockwise about 10
times so that they can be removed together.
Loosen the bolts of the joint by the hex wrench and
remove the angle housing, the joint and the socket.
1 2
4
003069
To install the socket and the joint, fit the socket to the
spindle so that the two faces are fitted perfectly. Then
install the joint. For higher speed operation, fit the angle
housing marked "LOW" to the joint. For lower speed
operation, fit the angle housing marked "HIGH" to the
joint.
1 2
5
6
For higher speed operation
003070
Rotate the angle housing to the desired position. Tighten
the bolt with the hex wrench firmly. And retighten the
another bolt firmly again.
003071
1. Hex wrench
2. Loosen
1. Angle housing
3 2. Joint
3. Socket
4. Bolt
1. Angle housing
3
4
2. Joint
3. Socket
4. Spindle
5. Low
6. High
7. Two faces
7
CAUTION:
Be sure to tighten the two bolts firmly, or it may
•
present a risk of injury to persons.
Slide the drill chuck to the spindle so that the two faces
are fitted perfectly. Holding the drill chuck with the chuck
key, tighten the bolt (for installing the drill chuck)
clockwise with the hex wrench firmly.
1
2
004658
1
2
4
004659
The tool may be converted to a conventional straight
drive drill by installing the drill chuck without the angle
attachment.
1 2
004660
Installing or removing drill bit
2
1
004661
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
6
1. Two faces
2. Drill chuck
3. Spindle
3
1. Drill chuck
2. Chuck key
3. Hex wrench
4. Tighten
3
1. Drill chuck
2. Spindle
1. Drill chuck
2. Tighten
3. Chuck key
3